PDA

View Full Version : race ready 383 small block (very strong)


suprsiz3_ls1
September 15th, 2008, 05:14 PM
I Have a good friend of mine thats selling his freshened-up 383 stroker motor. The only reason that he's selling the motor is becasue he's putting a 427 SB in the car. He's located in currituck NC
Here the specs:
Nickel Cad Block
4 Bolt Billet Main Caps
Eagle Rotating Assembly
Forged Crank
6in. h-Beam Rods
Dish Piston
New Rings/Bearings
Comp Cam/solid Tappet Roller
Comp Roller Lifters Cam part#12-771-8
Gross lift 1.5 Rocker Int.-.570/ Ehh.-.576
Gross lift 1.6 Rocker Int.-.608/ Exh.-.614
Duration .015 Tappet Lift Int.280/ Exh. 286
Duration .050 Int. -242/ Exh. -248
Cam Intalled 106 Int. Center line
Lobe separation 110
$3500
Heads Extra
Chevy Heads Cast #491
202 Int. Valves 160 Exh. Spring Set-up For Solid Tappet Roller
64 cc Chambers Straight Plug
Motor with heads 9:75:1 Compression Pump Gas
Sold with motor $750 (separate)$900
Before The Motor was Freshened up it was in a 66 Nova, that weighs 3500lbs with a turbo 350 tranny, 12 bolt with 3:73's, 3400-rpm stall
1/8 mile ran 7.4 N/A
1/8 mile ran 6.7 with 150 wet shot NOS Nitrous
1/4 mile ran 11.80 N/A
1/4 mile ran 10.7 with 150 wet shot NOS Nitrous
Contact info: Glennew57@mchsi.com (Glennew57@mchsi.com)


here are some picts of the car
http://i188.photobucket.com/albums/z253/suprsiz3_ls1/Camaro-Z28/glen7.jpg
http://i188.photobucket.com/albums/z253/suprsiz3_ls1/Camaro-Z28/glen5.jpg

suprsiz3_ls1
September 26th, 2008, 05:28 AM
come on folks this is a badd a$$ set up

suprsiz3_ls1
September 27th, 2008, 03:31 AM
thanks

gtoman33
September 27th, 2008, 09:43 AM
sweet soundin engine, I woulda went with flat top pistons though.... did he have it balanced and blueprinted? that's about what a friend of mine had, he had a demon 900 carb on it.... loved it... edelbrock highrise rpm performer intake... busted 2 trasmissions,lmao...